Unsubscribe please All the Best,

Robbie Sites POB 700 68 Good Samaritan Drive #504 Franklin, WV 26807 *cell: 304-668-4580* *sitesrd@gmail.com sitesrd@gmail.com *

On Tue, Sep 15, 2020 at 11:50 AM Glenn K0LNY glennervin@cableone.net wrote:

Hi Ted, Just a thought, did you use "run as administrator" when you installed it? Not doing so may cause problems. HTH.

Glenn

----- Original Message ----- From: "Ted" ted.g7obf@gmail.com To: "ask Q CHIRP software for radio" chirp_users@intrepid.danplanet.com Sent: Tuesday, September 15, 2020 10:44 AM Subject: [chirp_users] Error 5 - when trying to down load from KenwoodTS-2000

Hi

I running Windows 10 Build 19041 and Chirp build CHIRP daily-20200909 onHP Probook laptop with one only USB to serial adapter plugged in

To check com port selection (as shown on device manager) and that adpater/cableis working correctly I have used PuTTY to do loopback test to these instructions -

https://www.digi.com/support/knowledge-base/performing-a-com-port-loopback-t...

This checked out OK

When selecting Radio/download radio and enetering the data after clicking OK get message " An error has occured could not open port COM4 (error 5) Acess is denied"

I have checked the rig is powered up (can hear tones) and serial lead is firmly pushed into the radio's serial port

Suggestions please

73 de Ted G7oBF

---

chirp_users mailing list chirp_users@intrepid.danplanet.com http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to Glenn at glennervin@cableone.net To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com

---

chirp_users mailing list chirp_users@intrepid.danplanet.com http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to Robbie Sites at sitesrd@gmail.com To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com