Hi Ted,
Just a thought, did you use "run as administrator" when you installed it?
Not doing so may cause problems.
HTH.

Glenn

----- Original Message -----
From: "Ted" <ted.g7obf@gmail.com>
To: "ask Q CHIRP software for radio" <chirp_users@intrepid.danplanet.com>
Sent: Tuesday, September 15, 2020 10:44 AM
Subject: [chirp_users] Error 5 - when trying to down load from
KenwoodTS-2000


Hi

I running Windows 10 Build 19041 and Chirp build CHIRP daily-20200909
onHP Probook laptop with one only USB to serial adapter plugged in

To check com port selection (as shown on device manager) and that
adpater/cableis working correctly I have used PuTTY to do loopback test
to these instructions -
https://www.digi.com/support/knowledge-base/performing-a-com-port-loopback-test-using-putty

This checked out OK

When selecting Radio/download radio and enetering the data after
clicking OK get message " An error has occured could not open port
COM4 (error 5) Acess is denied"

I have checked the rig is powered up (can hear tones) and serial lead is
firmly pushed into the radio's serial port

Suggestions please

73 de Ted G7oBF

_______________________________________________
chirp_users mailing list
chirp_users@intrepid.danplanet.com
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
This message was sent to Glenn at glennervin@cableone.net
To unsubscribe, send an email to
chirp_users-unsubscribe@intrepid.danplanet.com

_______________________________________________
chirp_users mailing list
chirp_users@intrepid.danplanet.com
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
This message was sent to Robbie Sites at sitesrd@gmail.com
To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com