[chirp_users] Yaesu FT-7900 change memory content display
I have successfully programmed several hundred memory channels on my Yaesu FT-7900 using CHIRP.
Each memory channel is displayed as “memory address and LABEL".
I want each memory channel to display as “memory address and FREQUENCY" instead.
Is it possible to select / control this behavior through CHIRP ?
Do I need to edit my file to clear all labels and re-upload?
Thanks for anyone’s experience here.
Jerry AB3SX
There should be a way to change it universally with CHIRP, but I am not in a position right now to tell you what that method would be. You can press and hold the LOW button on the radio to change individual channels as needed, or should be able to press and hold the P2 or P4 button on the mic, depending on how these buttons are programmed.
Jardy Dawson WA7JRD Ham Radio
We keep trying to interfere with elections, but pesky moose and squirrel keep interfering!
On Sep 10, 2017, at 12:15, Jerome Whelan whelanjh@gmail.com wrote:
I have successfully programmed several hundred memory channels on my Yaesu FT-7900 using CHIRP.
Each memory channel is displayed as “memory address and LABEL".
I want each memory channel to display as “memory address and FREQUENCY" instead.
Is it possible to select / control this behavior through CHIRP ?
Do I need to edit my file to clear all labels and re-upload?
Thanks for anyone’s experience here.
Jerry AB3SX _______________________________________________ chirp_users mailing list chirp_users@intrepid.danplanet.com http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to Jardy at jardy72@yahoo.com To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com
Try the 'settings' tab in Chirp.
On 10 September 2017 at 15:15 Jerome Whelan <whelanjh@gmail.com> wrote: I have successfully programmed several hundred memory channels on my Yaesu FT-7900 using CHIRP. Each memory channel is displayed as “memory address and LABEL". I want each memory channel to display as “memory address and FREQUENCY" instead. Is it possible to select / control this behavior through CHIRP ? Do I need to edit my file to clear all labels and re-upload? Thanks for anyone’s experience here. Jerry AB3SX _______________________________________________ chirp_users mailing list chirp_users@intrepid.danplanet.com http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to Nigel Gunn, W8IFF at nigel@ngunn.net To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com
Nigel A. Gunn, 1865 El Camino Drive, Xenia, OH 45385-1115, USA. tel +1 937 825 5032 Amateur Radio G8IFF W8IFF (was KC8NHF 9H3GN), e-mail nigel@ngunn.net www http://www.ngunn.net Member of ARRL, QRPARCI #11644, SOC #548, Flying Pigs QRP Club International #385, Dayton ARA #2128, AMSAT-NA LM-1691, GCARES, EAA382.
participants (3)
-
Jardy Dawson -
Jerome Whelan -
Nigel A. Gunn G8IFF/W8IFF