Try the 'settings' tab in Chirp.

On 10 September 2017 at 15:15 Jerome Whelan <whelanjh@gmail.com> wrote:

I have successfully programmed several hundred memory channels on my Yaesu FT-7900 using CHIRP.

Each memory channel is displayed as “memory address and LABEL".

I want each memory channel to display as “memory address and FREQUENCY" instead.

Is it possible to select / control this behavior through CHIRP ?

Do I need to edit my file to clear all labels and re-upload?

Thanks for anyone’s experience here.

Jerry AB3SX

_______________________________________________
chirp_users mailing list
chirp_users@intrepid.danplanet.com
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
This message was sent to Nigel Gunn, W8IFF at nigel@ngunn.net
To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com

Nigel A. Gunn, 1865 El Camino Drive, Xenia, OH 45385-1115, USA. tel +1 937 825 5032
Amateur Radio G8IFF W8IFF (was KC8NHF 9H3GN), e-mail nigel@ngunn.net www http://www.ngunn.net
Member of ARRL, QRPARCI #11644, SOC #548, Flying Pigs QRP Club International #385,
Dayton ARA #2128, AMSAT-NA LM-1691, GCARES, EAA382.