[chirp_users] Channel program problem
I've a Baofeng UV-5RA and when importing local repeaters in Chirp (only been using since 1/11 & VIP before then & same problem), in Channel Mode it will not ping one of 4 local repeaters but if I set it in VFO Mode, no problems. In Channel Mode, I can hear other local repeaters but one I've programmed; RX Freq.=147.180 TX Freq.=147.780 Tone=151.4 Offset=00.600
FYI, I've 2 other Ts, a Yaseau FT-11 & a B-K LPH-5142 of which both can get the repeater, I can't talk to either of these from my Baofeng While in Channel Mode but can in VFO Mode. Any suggestions appreciated. 73s Bill
Bill, With CHIRP set the following columns up as shown below
Frequency=147.180000 Tone Mode=Tone Tone=151.4 Duplex=+ Offset=0.600000 Mode=FM Power=Low or High
Jim
On Sun, Jan 20, 2013 at 5:59 PM, Bill Gabbard wcgabbard1@windstream.netwrote:
** I've a Baofeng UV-5RA and when importing local repeaters in Chirp (only been using since 1/11 & VIP before then & same problem), in Channel Mode it will not ping one of 4 local repeaters but if I set it in VFO Mode, no problems. In Channel Mode, I can hear other local repeaters but one I've programmed; RX Freq.=147.180 TX Freq.=147.780 Tone=151.4 Offset=00.600
FYI, I've 2 other Ts, a Yaseau FT-11 & a B-K LPH-5142 of which both can get the repeater, I can't talk to either of these from my Baofeng While in Channel Mode but can in VFO Mode. Any suggestions appreciated. 73s Bill
chirp_users mailing list chirp_users@intrepid.danplanet.com http://intrepid.danplanet.com/mailman/listinfo/chirp_users
participants (2)
-
Bill Gabbard -
Jim Unroe