you did not have to use your hunch if you read miklor carefuly the 2 posibilities mentioned by jim are talked about there
2016-03-05 15:50 GMT+02:00 Jim Unroe rock.unroe@gmail.com:
On Sat, Mar 5, 2016 at 12:55 AM, Lee Houde houdatto@gmail.com wrote:
I built a cloning cable from scratch today - but it didn't work. I had
the
red wire soldered to the TX pin and the white wire soldered to the RX
pin as
the Miklor instructions stated. On a hunch, I reversed the RX/TX wires
and
now it WORKS! The board had the RX and TX markings reversed. BTW my board has LED lights on it so while I am downloading/uploading I get a little light show!
Unfortunately the labeling on the boards is not consistent.
On some boards...
TX means "TX". Connect it to RX on the other end. RX means "RX" Connect it to TX on the other end.
On other boards...
TX means "to TX". Connect it to TX on the other end. RX means "to RX". Connect it to RX on the other end.
Jim KC9HI _______________________________________________ chirp_users mailing list chirp_users@intrepid.danplanet.com http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to amnon at amnon.zohar@gmail.com To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com