On Sat, Mar 5, 2016 at 12:55 AM, Lee Houde <houdatto@gmail.com> wrote:
> I built a cloning cable from scratch today - but it didn't work. I had the
> red wire soldered to the TX pin and the white wire soldered to the RX pin as
> the Miklor instructions stated. On a hunch, I reversed the RX/TX wires and
> now it WORKS! The board had the RX and TX markings reversed. BTW my board
> has LED lights on it so while I am downloading/uploading I get a little
> light show!
>

Unfortunately the labeling on the boards is not consistent.

On some boards...

TX means "TX". Connect it to RX on the other end.
RX means "RX" Connect it to TX on the other end.

On other boards...

TX means "to TX". Connect it to TX on the other end.
RX means "to RX". Connect it to RX on the other end.

Jim KC9HI
_______________________________________________
chirp_users mailing list
chirp_users@intrepid.danplanet.com
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
This message was sent to amnon at amnon.zohar@gmail.com
To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com