There are diagrams and pinouts of the 1799 cable if you Google mine say 1799 pinout. I guess what's needed is a TX and RX line and ground. Now if you can find a USB to serial data cable without a combined RX and TX line you could rig something up. I did something similar with my RTSystems DB9 to Mini DIN 6 pin. I cut the DB9 off, found the wire for pin 6, serial data input and pin 5 (I think) for ground. The Yaesu uses one wire for both TX and RX and my spare cable also supplies one wire for ground and one wire for data. But you need full duplex so you need a full duplex cable that you could just wire a DB9 to or get the 1799 and cut the DB9 off and basically you would have just 3 connections. I've found a lot of sites offering diagrams by using Google and setting the search for images. If you have a cable that has that special connector on it you can get the pinout for it I'm sure. Just takes a little leg work.
On Tue, Apr 22, 2014 at 1:59 PM, Dwayne drichnews@gmail.com wrote:
Thanks for all of your help. I am really surprised someone hasn't built a cable that eliminates the db9 connector.
Dwayne
On Apr 22, 2014, at 13:42, Milton thecanesvenatici@gmail.com wrote:
Just google USB to DB9. I buy stuff from Amazon and this will probably do the job along with the 1799 cable
http://www.amazon.com/C2G-Cables-26886-Serial-Adapter/dp/B000067RVJ
On Tue, Apr 22, 2014 at 1:05 PM, dwayne rich drichnews@gmail.com wrote:
so you are saying the only cable that will work with chirp and the IC-92AD is the icom cable that plug directly into the 92AD and has the RS232 end? Is there any RS232 adapter that will wor with this cable and chirp as all of my computers have USB ports and no RS232 port. Is there any hope that this will change in Chirp in the future so the OPC478 cable can be used?
Dwayne
On Tue, Apr 22, 2014 at 12:44 PM, Dan Smith dsmith@danplanet.com wrote:
well the program tested the cable and said it is working just fine. I tested it both with and without the opc-1797 cable attached with the
same
results. So that would seem to indicate a problem with the radio or
chirp.
The cable you need to use with the 92AD would fail a loopback test because it's not a looped cable. If that test passes, then I'd expect you're using an OPC-478 and the bayonet adapter to connect it. If so, that won't work with CHIRP. CHIRP talks to the 92AD in live high-speed mode, which doesn't require going into clone mode, and which won't work with the OPC-478.
See the entry for the 92AD on the CableGuide page:
http://chirp.danplanet.com/projects/chirp/wiki/CableGuide#IC-91AD-IC-92AD-ID...
--Dan
chirp_users mailing list chirp_users@intrepid.danplanet.com http://intrepid.danplanet.com/mailman/listinfo/chirp_users
chirp_users mailing list chirp_users@intrepid.danplanet.com http://intrepid.danplanet.com/mailman/listinfo/chirp_users
chirp_users mailing list chirp_users@intrepid.danplanet.com http://intrepid.danplanet.com/mailman/listinfo/chirp_users
chirp_users mailing list chirp_users@intrepid.danplanet.com http://intrepid.danplanet.com/mailman/listinfo/chirp_users