Anybody has an idea how to release? Maybe contact spray? Are the contactor accesible by opening the unit?
בתאריך יום ב׳, 12 בנוב' 2018, 22:07, מאת Glenn At Home < GlennErvin@cableone.net>:
I have one that this happened to, and I can only use the external speaker-mic now. Glenn ----- Original Message ----- *From:* Amnon Zohar amnon.zohar@gmail.com *To:* Discussion of CHIRP chirp_users@intrepid.danplanet.com *Sent:* Monday, November 12, 2018 10:26 AM *Subject:* Re: [chirp_users] problem with baofeng uv-5r
Tx jim ill check with external mic. Any suggestion to solve it?
בתאריך יום ב׳, 12 בנוב' 2018, 16:36, מאת Jim Unroe rock.unroe@gmail.com:
On Mon, Nov 12, 2018 at 8:55 AM Amnon Zohar amnon.zohar@gmail.com wrote:
not exactly a chirp issue:
i have few uv-5r's
one of them can only receive while transmitting the others receive only the bip but not the voice~ what might be the reason besides a defective mic
When a external device (speaker/mic, programming cable, etc.) is plugged into the socket of the radio, 2 contacts are lifted to disconnect the internal microphone and the internal speaker. It is common in these radios for the contact to not fully return to the initial position when the 2-pin plug is removed. When this happens, the internal mic and/or speaker remains disconnected.
(while checking i found out i cannot manualy change menu 5 from wide to
narrow . it remais as programmed - this IS a chirp issue(
This is not a CHIRP issue. This is how the radio works. You cannot permanently change any parameter of a programmed memory. You can only temporarily change TX power output level by tapping the [#] or swap the TX and RX frequencies by tapping the [*] to put the radio into "reverse" mode.
You can only manually update the TX frequency and either the TX DCS code or TX CTCSS tone by entering the values in the top (A) VFO and then write the new values to the appropriate memory using menu 28 (MEM-CH). To change any other parameter, including menu 5 (W/N), you must erase the memory and program the memory back from scratch using the top (A) VFO or use programming software such as CHIRP.
-- Amnon
Jim KC9HI _______________________________________________ chirp_users mailing list chirp_users@intrepid.danplanet.com http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to amnon at amnon.zohar@gmail.com To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com
chirp_users mailing list chirp_users@intrepid.danplanet.com http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to Glenn at glennervin@cableone.net To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com _______________________________________________ chirp_users mailing list chirp_users@intrepid.danplanet.com http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to amnon at amnon.zohar@gmail.com To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com