I have one that this happened to, and I can only
use the external speaker-mic now.
Glenn
----- Original Message -----
Sent: Monday, November 12, 2018 10:26 AM
Subject: Re: [chirp_users] problem with baofeng uv-5r
Tx jim ill check with external mic. Any suggestion to solve it?
On
Mon, Nov 12, 2018 at 8:55 AM Amnon Zohar <amnon.zohar@gmail.com> wrote:
>
> not exactly
a chirp issue:
>
> i have few uv-5r's
>
> one of them
can only receive
> while transmitting the others receive only the bip
but not the voice~
> what might be the reason besides a defective
mic
When a external device (speaker/mic, programming cable, etc.)
is
plugged into the socket of the radio, 2 contacts are lifted
to
disconnect the internal microphone and the internal speaker. It
is
common in these radios for the contact to not fully return to
the
initial position when the 2-pin plug is removed. When this
happens,
the internal mic and/or speaker remains
disconnected.
>
> (while checking i found out i cannot manualy
change menu 5 from wide to narrow . it remais as programmed - this IS a chirp
issue(
This is not a CHIRP issue. This is how the radio works. You
cannot
permanently change any parameter of a programmed memory. You can
only
temporarily change TX power output level by tapping the [#] or
swap
the TX and RX frequencies by tapping the [*] to put the radio
into
"reverse" mode.
You can only manually update the TX frequency
and either the TX DCS
code or TX CTCSS tone by entering the values in the
top (A) VFO and
then write the new values to the appropriate memory using
menu 28
(MEM-CH). To change any other parameter, including menu 5 (W/N),
you
must erase the memory and program the memory back from scratch
using
the top (A) VFO or use programming software such as
CHIRP.
>
> --
> Amnon
Jim
KC9HI
_______________________________________________
chirp_users
mailing list
chirp_users@intrepid.danplanet.com
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
This
message was sent to amnon at amnon.zohar@gmail.com
To unsubscribe, send
an email to chirp_users-unsubscribe@intrepid.danplanet.com
_______________________________________________
chirp_users mailing
list
chirp_users@intrepid.danplanet.comhttp://intrepid.danplanet.com/mailman/listinfo/chirp_usersThis
message was sent to Glenn at
glennervin@cableone.netTo unsubscribe, send an
email to
chirp_users-unsubscribe@intrepid.danplanet.com
_______________________________________________