22 Aug
2020
22 Aug
'20
9:18 p.m.
Thanks for the suggestion, I cleaned the prongs with alcohol I'll clean the base and try again.
On August 22, 2020 at 3:50 PM Jim Unroe < rock.unroe@gmail.com mailto:rock.unroe@gmail.com > wrote:
On Sat, Aug 22, 2020 at 6:46 PM Charles Gierke < cgierke@cox.net mailto:cgierke@cox.net > wrote: > > > On Wednesday my 2 BaoFeng UV 5R radios could download and upload to CHIRP.>> > On Friday all I got was the following message: Radio Did Not Respond.>> > I tried reloading the latest version of CHIRP, no change. I tried an earlier version of CHIRP, no change. I reloaded the latest version back, no change. Visually the radio's red light blinks then the LED display blinks then the error message shows up on CHIRP.> >> > Any suggestions?>> > Thanks Chuck KJ7INT> Hi Chuck,You will get the exact same error message if you don't plug the 2-pin plug into the radio. So make sure that the 2-pin plug is fully inserted into the socket of the radio. Some have had to put a little pressure on the plug during the cloning process. Jim KC9HI _______________________________________________ chirp_users mailing list chirp_users@intrepid.danplanet.com mailto:chirp_users@intrepid.danplanet.com http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to Chuck at cgierke@cox.net mailto:cgierke@cox.net To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com mailto:chirp_users-unsubscribe@intrepid.danplanet.com