On August 22, 2020 at 3:50 PM Jim Unroe < rock.unroe@gmail.com> wrote:


On Sat, Aug 22, 2020 at 6:46 PM Charles Gierke < cgierke@cox.net> wrote:
>

On Wednesday my 2 BaoFeng UV 5R radios could download and upload to CHIRP.

On Friday all I got was the following message: Radio Did Not Respond.

I tried reloading the latest version of CHIRP, no change. I tried an earlier version of CHIRP, no change. I reloaded the latest version back, no change. Visually the radio's red light blinks then the LED display blinks then the error message shows up on CHIRP.

>

Any suggestions?

Thanks Chuck KJ7INT

Hi Chuck,

You will get the exact same error message if you don't plug the 2-pin
plug into the radio. So make sure that the 2-pin plug is fully
inserted into the socket of the radio. Some have had to put a little
pressure on the plug during the cloning process.

Jim KC9HI
_______________________________________________
chirp_users mailing list
chirp_users@intrepid.danplanet.com
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
This message was sent to Chuck at cgierke@cox.net
To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com