[chirp_users] Kenwood TM-D710 problems...
I can't connect to my TM-D710. If I select Kenwood & Detect, it says Unsupported Model TM-D710P, if I select Kenwood & tell it I have a TM-D710, it just goes back to a blank Chirp page...
Ideas?
73, Ross N4RP
Never mind... Have to use the PC connection on the back of the main body, not the one on the control head....
73, Ross N4RP
On 5/22/2013 2:33 PM, Ross Primrose N4RP wrote:
I can't connect to my TM-D710. If I select Kenwood & Detect, it says Unsupported Model TM-D710P, if I select Kenwood & tell it I have a TM-D710, it just goes back to a blank Chirp page...
Ideas?
73, Ross N4RP
On Wed, May 22, 2013 at 11:33 AM, Ross Primrose N4RP n4rp@n4rp.com wrote:
I can't connect to my TM-D710. If I select Kenwood & Detect, it says Unsupported Model TM-D710P, if I select Kenwood & tell it I have a TM-D710, it just goes back to a blank Chirp page...
Ideas?
73, Ross N4RP
You're plugged into the back of the RF deck right? The control head port is for TNC access only.
Tom KD7LXL
participants (2)
-
Ross Primrose N4RP -
Tom Hayward