CHIRP remembers the last com port it used.

It doesn't check to see if you changed USB slots.

I run the port scan below.

http://wouxun.us/Software/USB Drivers/FindComPort.exe http://wouxun.us/Software/USB%20Drivers/FindComPort.exe

Then type over the CHIRP selected port.

Hope this helps.

John K3NXU

BTW: I use Windows7 and a Dell POS

From: chirp_users-bounces@intrepid.danplanet.com [mailto:chirp_users-bounces@intrepid.danplanet.com] On Behalf Of John Gorena Sent: Saturday, October 27, 2012 11:36 AM To: 'Discussion of CHIRP' Subject: Re: [chirp_users] Daily Build chirp-daily-20121019-installer.exe

If no one else sees this issue, it is probably my laptop. Acting funny - but it is not making me laugh. Just saying.

John

From: chirp_users-bounces@intrepid.danplanet.com [mailto:chirp_users-bounces@intrepid.danplanet.com] On Behalf Of John Gorena Sent: Saturday, October 27, 2012 9:39 AM To: 'william coulson'; 'Discussion of CHIRP' Subject: [chirp_users] Daily Build chirp-daily-20121019-installer.exe

On Daily Build chirp-daily-20121019-installer.exe, it does not let me change the COM port. It is set on com6 and click on arrow and it only lists com6. Is anyone else seeing this issue?

- I am using Windows 7 Ultimate laptop

- Connected to a Yaesu FT8900

John