[chirp_users] repeater programming on UV5R
I am having a problem programming a couple of my local 70cm repeaters into my baofang UV5R. The problem is that I can access the repeater but although the repeater responds, as indicated by the green light being lit, I hear no audio. This is because R-CTCss is set to on. These two repeaters do not transmit a CTCss tone so I need to program R-CTCSS off on the radio but so far I have been unsuccessful in doing this! Manually loading the repeater into the radio it all works fine, just using a memory channel programmed with Chirp. It is just two repeaters that give probs. all others are OK.
So question is how do I program the R-CTCss off for these two memory channels, but leave T-CTCss active of course.
Martin G3ZQU.
On Wed, Aug 19, 2015 at 2:45 PM, Martin Goodrum g3zqu@btinternet.com wrote:
I am having a problem programming a couple of my local 70cm repeaters into my baofang UV5R. The problem is that I can access the repeater but although the repeater responds, as indicated by the green light being lit, I hear no audio. This is because R-CTCss is set to on. These two repeaters do not transmit a CTCss tone so I need to program R-CTCSS off on the radio but so far I have been unsuccessful in doing this! Manually loading the repeater into the radio it all works fine, just using a memory channel programmed with Chirp. It is just two repeaters that give probs. all others are OK.
So question is how do I program the R-CTCss off for these two memory channels, but leave T-CTCss active of course.
Martin G3ZQU.
For menu 13 (T-CTCS) = {tone frequency} and menu 11 (R-CTCS) = OFF
Tone Mode = Tone Tone = {tone frequency}
Jim KC9HI
participants (2)
-
Jim Unroe -
Martin Goodrum