[chirp_users] Programming 2 distinct frequencies.
I noticed that when programming a repeater pair, Chirp defaults to a + or - 600 kcs which is the standard ham practice. I don't see where I can deviate from that. What I want to do specifically is program in 160.770 as the uplink and 160.230 as the downlink.
Paul WA6OKQ
I would just delete the 600 kHz and the plus or minus, and then put in the two frequencies. HTH. Glenn ----- Original Message ----- From: "Paul Veltman" stumpie1@sbcglobal.net To: chirp_users@intrepid.danplanet.com Sent: Saturday, August 05, 2017 9:08 PM Subject: [chirp_users] Programming 2 distinct frequencies.
I noticed that when programming a repeater pair, Chirp defaults to a + or - 600 kcs which is the standard ham practice. I don't see where I can deviate from that. What I want to do specifically is program in 160.770 as the uplink and 160.230 as the downlink.
Paul WA6OKQ _______________________________________________ chirp_users mailing list chirp_users@intrepid.danplanet.com http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to Glenn at glennervin@cableone.net To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com
On Sat, Aug 5, 2017 at 10:08 PM, Paul Veltman stumpie1@sbcglobal.net wrote:
I noticed that when programming a repeater pair, Chirp defaults to a + or - 600 kcs which is the standard ham practice. I don't see where I can deviate from that. What I want to do specifically is program in 160.770 as the uplink and 160.230 as the downlink.
Paul WA6OKQ
You didn't say which radio you have. But on a radio that supports it...
Frequency: 160.770 Duplex: split Offset: 160.230
When Duplex is set to split, the Offset column contains the TX frequency.
Jim KC9HI
participants (3)
-
Glenn At Home -
Jim Unroe -
Paul Veltman