[chirp_users] Dstar ID-RP4000V Repeater
I have an ICOM , ID-RP4000V Dstar repeater. According to the Wiki page both the VHF and UHF repeater is supported. When I check the daily build list it is not shown as supported and I could not locate a *.py file for the repeater. I have been through the archives and found reference that support for the ID-RP400V was added and it was working , but not much other info. When I run Chirp to try detect the repeater/radio I get an error message " An error has occurred Unable to get radio model". I have tried both the most up to date windows version and a USB thumb drive with the Live CD loaded. Both versions operate fine , but with the error message. Any suggestions????
Bob K7MHJ
You may need the drivers for the Icom USB interfaces from the Icom install disk. They are somewhat unique.
Mike va3mw
On Sat, Nov 8, 2014 at 11:35 PM, Robert Keeton rkeeton@blarg.net wrote:
Bob,
The CHIRP driver is idrp.py and for some reason it does not show up as a choice in CHIRP (I believe it should be "ID-2000V/4000V/2D/2V"). Most of the activity of this driver appears to be from 2009 to 2012. I installed a daily build from May of 2012 and March of 2012 and there was still not a selection for this Icom model.
Jim KC9HI
On Sat, Nov 8, 2014 at 11:35 PM, Robert Keeton rkeeton@blarg.net wrote:
participants (3)
-
Jim Unroe
-
Michael Walker
-
Robert Keeton