[chirp_users] error message when attempting to connect to CHIRP
I have a Rugged RH5R-V@ (Baofeng UV5) and a Baofeng UV82C.
I have a Baofeng PC03 FTDI dual pin cable.
When I attempt to download my radio's information (rugged rh5r) while connected to CHIRP, following all instructions, I receive the error massage;
"An error has occurred" Radio did not respond.
Can someone help me figure out what the problem is?
Dennis Boxdorfer
On Fri, Jan 3, 2020 at 12:20 AM dennis@dencoconstruction.net wrote:
I have a Rugged RH5R-V@ (Baofeng UV5) and a Baofeng UV82C.
I have a Baofeng PC03 FTDI dual pin cable.
When I attempt to download my radio’s information (rugged rh5r) while connected to CHIRP, following all instructions, I receive the error massage;
“An error has occurred” Radio did not respond.
Can someone help me figure out what the problem is?
Dennis Boxdorfer
Hi Dennis,
Assuming that this programming cable works fine for the UV-82C, the most likely cause of this error is that the connection between the 2-pin plug of the programming cable and speaker/mic socket of the RH-5R is not fully made. You may have to put pressure on the plug toward the socket during the cloning process.
Jim KC9HI
Dennis, This may assist.
www.Miklor.com/COM/UV_ErrorMess.php
John
On Fri, Jan 3, 2020 at 12:20 AM dennis@dencoconstruction.net wrote:
I have a Rugged RH5R-V@ (Baofeng UV5) and a Baofeng UV82C.
I have a Baofeng PC03 FTDI dual pin cable.
When I attempt to download my radio’s information (rugged rh5r) while connected to CHIRP, following all instructions, I receive the error massage;
“An error has occurred” Radio did not respond. Can someone help me figure out what the problem is?
Dennis Boxdorfer
participants (3)
-
dennis＠dencoconstruction.net -
Jim Unroe -
John LaMartina