[chirp_users] daily build won't run
The last two daily builds won't execute as In get an error message ?unable to verify". I have never had this problem prior to these two builds. I'm running windows 7 under 10. Any ideas?
Ditch Win 7. It runs better on Win 10.
On 18/01/2022 12:27 Chuck OConnor dalmations@juno.com wrote:
The last two daily builds won't execute as In get an error message ?unable to verify". I have never had this problem prior to these two builds. I'm running windows 7 under 10. Any ideas? _______________________________________________ chirp_users mailing list chirp_users@intrepid.danplanet.com http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to Nigel Gunn, W8IFF at nigel@ngunn.net To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com
Nigel A. Gunn, ///shoulders.outwards.resolutions tel +1-937-971-0366 Amateur Radio G8IFF W8IFF and GMRS WRBV701, e-mail nigel@ngunn.net www http://www.ngunn.net
Hi Chuck,
The last two daily builds won't execute as In get an error message
?unable to verify". I have never had this problem prior to these two builds. I'm running windows 7 under 10. Any ideas?
When you upgraded CHIRP, you didn't make the mistake of executing the installer while CHIRP was running, did you?
[image: CHIRP Install - 0.png]
If you click [ OK ] at the "A new version of CHIRP is available" notification, you must at some point close CHIRP prior to launching the installer or won't/can't be upgraded properly.
I usually choose [ Cancel ] and then close CHIRP. The I go to the CHIRP website and get the latest build. I just that to upgrade my CHIRP development computer (Windows 7 32-bit) and all is well here.
Jim KC9HI
participants (3)
-
Chuck OConnor -
Jim Unroe -
Nigel A. Gunn G8IFF/W8IFF