Hello all,

This is not stricly Chirp related but I need you help on programming my radios with selective DCS.

I use the radios in a car racing team and I need to be abe to talk to this car or that car but also to all the cars at the same time.

I have made a setup which runs fine to speak to each car individualy but I can't talk to all of them at the same time, here's what I did.

Same frequency for all channels

DCS RX specific to each car (X for car 1, Y for car 2, etc.....) No DCS TX on the cars radios so that when the driver speaks everyone car hear it (except the other cars of course) I made several channels on the pit radios with a matching DCS TX for car 1, car 2 and no DCS at all to be able to talk to the other pits radios)

I'd like to make a new DCS RX on all cars (200) so that I could talk to ALL cars at the same time but when I program it on the cars radios it does not work, the car does not receive it.

I made a dual watch so that the car receiving radio should switch from the "this car only" channel to the "all cars channel" but somehow it does not receive.

What did I do wrong ?

Thanks for the help