Yes, Mine only does the carrier with no
modulation, unless I plug in the speaker-mic.
So without the speaker-mic, it's just the same
issue you describe.
I've tried repeated plug-ins to unstick it, but I
guess I'm stuck with only using a speaker-mic on that radio.
I don't know if an earphone would do the same to
a Baofeng.
HTH.
Glenn
----- Original Message -----
Sent: Monday, June 06, 2022 1:23 PM
Subject: Re: [chirp_users] What is wrong here?
No, I never have - at least not that I recall. You said that it
will only transmit via the speaker mic ... mine is transmitting a carrier but
there's no modulation. If your experience is similar, I might try
plugging in one of the ones I have. I haven't because I heard reports
that they cause it to stick but there hasn't been a good discussion that I've
seen regarding the symptoms of "sticking".
------ Original Message ------
Date Mon 6 6 22 12:12:58
Subject Re: [chirp_users] What is wrong here?
Did you ever plug in a speaker
microphone?
My UV5R is known for sticking inside and it
will only transmit the microphone via the speaker microphone.
I don't want to open it up to try and unstick
the contact inside the jack.
Glenn
----- Original Message -----
Sent: Monday, June 06, 2022 11:50 AM
Subject: Re: [chirp_users] What is wrong here?
according to Chirp there is nothing set for tone or DTCS on the GMRS
channels (frequencies) lines 31 - 52l the only exception is line 53 where I
have a positive offset for the local GMRS repeater.
The problem is that I'm sending a carrier but no voice on the
carrier. Reception is fine all the way 'round,
//al
------ Original Message ------
Date Mon 6 6 22 11:10:42
Subject Re: [chirp_users] What is wrong here?
Do you have CTCSS tones set on the receive side.
If so, remove them.
It’s possible the repeaters aren’t sending a tone back to you..
Stay Safe and Stay Healthy John Miklor
Attached is the image of my 'working' radio - problem is, it's not
working right. This an older Baofeng UV-82L much prior to the recent FCC
rule changes. I am both a licensed ham (KG5HEJ) and GMRS (WQYM836)
operator. Though I recognize the legalities of using this radio, it's
use in the GMRS bands is primarily for monitoring local tourists and
providing them with help.
That all out of the way. RX/TX on any of the ham bands is without
problem, I can talk with anyone on our local repeater system, or
simplex, without a problem (barring mountains which are occasional
problems) on the GMRS freqs, I'm seeing (on my BCT15X scanner) a carrier
being transmitted in the appropriate freq but hearing no voice on the
carrier on both the one GMRS repeater channel and simplex. I and a
friend have been all over these settings and I hope we're just missing
the obvious (obvious to someone else.)
Anyone ???
//al KG5HEJ
_______________________________________________
chirp_users
mailing list
chirp_users@intrepid.danplanet.com
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
This
message was sent to K0LNY at glenn@ervin.email
To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com
To
report this email as off-topic, please email chirp_users-owner@intrepid.danplanet.com
_______________________________________________
chirp_users mailing
list
chirp_users@intrepid.danplanet.comhttp://intrepid.danplanet.com/mailman/listinfo/chirp_usersThis
message was sent to K0LNY at glenn@ervin.email
To unsubscribe, send an
email to
chirp_users-unsubscribe@intrepid.danplanet.comTo report
this email as off-topic, please email
chirp_users-owner@intrepid.danplanet.com
_______________________________________________