I also have to hold the plug in while reading and writing. I have other Baofeng’s that I do not have this issue with. It may be that I need to shave the edges like I have done for other radios.
JB, N4NQY
From: chirp_users-bounces@intrepid.danplanet.com [mailto:chirp_users-bounces@intrepid.danplanet.com] On Behalf Of Ken Palmer Sent: Saturday, May 30, 2015 8:21 PM To: Discussion of CHIRP Subject: Re: [chirp_users] I picked up a UV-B5 and am unable to program it with chirp.
I had that problem with one of mine.. seemed the plug in at radio wasn't plugged in all the way.. had to hold it in with left hand while sending or reading from radio.. that was my issue, it may be the same with yours.. maybe not but worth the effort to try
On May 28, 2015 1:10 PM, "Stan" k8ll.ham@gmail.com wrote:
Hi all.
This has been my experience with a UV5R. Maybe a little help?????
When I plug in my cable and turn on the radio (UV5R), it comes on in transmit mode, and stays key-down. As soon as I send the updated data to the radio, it will fail, but the radio will come out of transmit mode . . . USUALLY . . . BUT sometimes I have to send the data 2 or 3 times before it comes out of transmit mode. Then, after it's come out of transmit mode, it will accept the data OK. So, I try to tune to a frequency that most likely will not be in use when I turn the radio on, that way, when it starts up in transmit mode it won't interfere with someone else's QSO.
Also, and I'm not sure what chipset is in my cheap cable, I had to just roll the driver back to the previous driver BEFORE it would work. The next update made it fail again, so I rolled it back again and stopped it from updating the driver again and it has worked OK ever since.
Just my 2Hz worth!
73 Stan K8LL NW Ohio 10-10# 76801 FP# 3255 Propagation is our master . . . but sometimes the master is cruel! ------------------------------------------------------------
On 5/28/2015 3:00 PM, chirp_users-request@intrepid.danplanet.com wrote:
I picked up a UV-B5 and am unable to program it with chirp. The console
output is as follows:
%chirpw
ERROR: -- Exception: -- ERROR: Traceback (most recent call last): File "/usr/lib64/python2.7/site-packages/chirp/ui/clone.py", line 238, in run self.__radio.sync_in() File "/usr/lib64/python2.7/site-packages/chirp/drivers/uvb5.py", line 315, in sync_in self._mmap = do_download(self) File "/usr/lib64/python2.7/site-packages/chirp/drivers/uvb5.py", line 202, in do_download do_ident(radio) File "/usr/lib64/python2.7/site-packages/chirp/drivers/uvb5.py", line 181, in do_ident raise errors.RadioError("Radio did not ack programming mode") RadioError: Radio did not ack programming mode
ERROR: ---------------- ERROR: Clone failed: Radio did not ack programming mode ERROR: --- Exception Dialog: Radio did not ack programming mode --- ERROR: None
ERROR: ----------------------------
I've tried two different cables to no avail, and yes I had them seated. Not a windows environment so I don't think the IP hindrance is the issue. The radio's xmit light comes on but it seams to not be able to communicate with chirp.
_______________________________________________ chirp_users mailing list chirp_users@intrepid.danplanet.com http://intrepid.danplanet.com/mailman/listinfo/chirp_users To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com