I've seen so many email threads discussing the seating of the cable into the radio. Mine did not fit very well into my radio until I took a razor blade and cut a little bit of the rubber out of the corner of the connector. I have had no problems with that cable since. You need to feel that cable clicking into the radio and if you cut that excess rubber out of the way, then you will get that verification confirmation.
Walt N6STM 73
On Jan 8, 2017 2:00 PM, "Rich Messeder" rich.messeder@gmail.com wrote:
Greetings Harsha, When I first started w the Baofeng, I had cable trouble. I was advised to make sure that the connector to the radio was well seated. I checked it and it seemed fine. After several failed attempts, I took special care to see how well it seated, and found that it really must be /firmly/ pushed in to be fully seated. Since then, no problems with several releases of CHIRP.
~R~ NE1EE Rich Messeder Short email? No html? Here's why: http://emailcharter.org/
On 2017-01-08 10:30:-0700, Harsha Godavari wrote:
Thank you. Downloaded the 0161018 version and received the message, "An
error occurred Radio did not respond".
Somewhere there was a suggestion that the programming cable might need
some surgery ! At this point I don't feel brave enough :-)
Regards harsha godavari
chirp_users mailing list chirp_users@intrepid.danplanet.com http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to Walt Childson at wchildson@gmail.com To unsubscribe, send an email to chirp_users-unsubscribe@ intrepid.danplanet.com