Re: [chirp_users] Yaesu FT8900R Cloning

Thank you for your response.

i do select the serial port (com port).

I will I’ll have to research as I have never selected a USB port. I just plug it in to the USB on the computer

thanks again...stay safe and stay healthy

joe

On September 7, 2020 2:39 PM D.J.J. Ring, Jr. <n1ea@arrl.net> wrote:


You have to select the USB port that your radio is connected to.  

73

DR

On Mon, Sep 7, 2020 at 5:28 PM joe < joe@joeshapley.com mailto:joe@joeshapley.com > wrote:

    > >         Hi everyone,

...

    Windows 10 computer

    I am trying to clone the Yaesu FT8900R (this is the first time)

    I use CHIRP and I follow the CHIRP instructions (same as in Yaesu manual)

    I turn on the radio, go to F6 "clone start", then push "set"

    Nothing happens...after a few seconds, I get error message stating it could not find the item location (com port).  Tried several times on all four active ports.

    Checked "device manager" and the four ports are active and well

    Any help or suggestions will be greatly appreciated

    Joe
    _______________________________________________
    chirp_users mailing list
    chirp_users@intrepid.danplanet.com mailto:chirp_users@intrepid.danplanet.com
    http://intrepid.danplanet.com/mailman/listinfo/chirp_users
    This message was sent to D.J.J. Ring, Jr. at n1ea@arrl.net mailto:n1ea@arrl.net
    To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com mailto:chirp_users-unsubscribe@intrepid.danplanet.com

>     _______________________________________________

chirp_users mailing list
chirp_users@intrepid.danplanet.com
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
This message was sent to joe Shapley at joe@joeshapley.com
To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com