Hi
I have programming cables for the Baofeng UV-5R and a Yaesu VX-7R which I suspect are based on cloned Prolific chips and give me no end of trouble with Chirp (and VX Commander for the Yaesu)
I spotted the Miklor website that gives information about building a cable for the Baofeng using a CP2102 USB/TTL UART.
http://www.miklor.com/COM/UV_Technical.php#progcable
I was thinking that rather than soldering the cable for the Baofeng directly to the UART board I could put the board in a small box with a USB extension lead one side and with a 3.5mm stereo jack on the other. I would then terminate the programming lead for each radio with a 3.5mm plug wired appropriately. The Baofeng connections I can take from the Miklor website above but what would I need for the VX-7R?
I found this pin out for the VX-7R
http://www.kc8unj.com/pinout.jpg
This seems to be similar to the Baofeng UV-3R (as shown on the Miklor page) but is a Ground connection required?
73
Mark GW7KDU Cardiff, UK