Is the radio turned ON? Sometimes you have to not only turn them on but also crank the volume to max.
On Sat, Dec 7, 2019, 6:44 PM Tom Henderson Tom@henderson4.us wrote:
Adding yourself to the "dialout" group should prevent you from having to do this.
Tom Henderson
On 12/7/19 6:58 PM, Pat Anderson wrote:
Oops, I should have said I am running Ubuntu Linux. Can't say anything if you are running something other than Linux.
On Sat, Dec 7, 2019 at 5:56 PM Pat Anderson anderson5420@gmail.com wrote:
Try this. Before you try to read from the radio, do "chmod 777 /dev/ttyUSB0". I have a Baofeng UV82HP and CHIRP reads and writes just fine once I have done this.
Pat Anderson KD7OAC
On Sat, Dec 7, 2019 at 5:48 PM Phil phillor9@gmail.com wrote:
Thank you for reading this.
I bought a Baofeng UV-82HP about four months ago and I cannot get Chirp to read from the radio, or in fact to do anything with the radio.
I'm running Chirp under Kubuntu and have tried every Chip daily version over the past four months. This is the error message that I receive when I attempt to read from the radio:
"Radio did not respond"
These are the entered parameters:
/dev/ttyUSB0 Baofeng UV-82HP
I have read and write access to the serial port which is the same port that I use for several application including programming an Arduino board. I have tried several different Baofeng models, just in case, with the same result.
I've trimmed the plastic from the plug so that it slips into the radio's sockets more easily. I've attempted to read from the radio in both channel and frequency modes. Finally, I've searched the Internet for even the slightest clue but to no avail.
I do not know anyone who owns a Baofeng radio or who uses Chirp. So this mailing list is my last hope.
Any clues at all will greatly appreciated.
-- Regards, Phil
chirp_users mailing list chirp_users@intrepid.danplanet.com http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to Pat Anderson at anderson5420@gmail.com To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com
chirp_users mailing listchirp_users@intrepid.danplanet.comhttp://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to Tom KM4UQB at tom@henderson4.us To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com
chirp_users mailing list chirp_users@intrepid.danplanet.com http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to Ryan McOmber at volksmech@gmail.com To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com