On Sat, Mar 5, 2016 at 12:55 AM, Lee Houde houdatto@gmail.com wrote:
I built a cloning cable from scratch today - but it didn't work. I had the red wire soldered to the TX pin and the white wire soldered to the RX pin as the Miklor instructions stated. On a hunch, I reversed the RX/TX wires and now it WORKS! The board had the RX and TX markings reversed. BTW my board has LED lights on it so while I am downloading/uploading I get a little light show!
Unfortunately the labeling on the boards is not consistent.
On some boards...
TX means "TX". Connect it to RX on the other end. RX means "RX" Connect it to TX on the other end.
On other boards...
TX means "to TX". Connect it to TX on the other end. RX means "to RX". Connect it to RX on the other end.
Jim KC9HI