I use it on pc to program icom units no issues unless win 10 has done an update which knocks the driver around
-------- Original message --------
From: Ken Vernon <kennethjv@bigpond.com>
Date: 21/11/20 13:33 (GMT+10:00)
To: Discussion of CHIRP <chirp_users@intrepid.danplanet.com>
Subject: Re: [chirp_users] Programming Baofeng GT3 - Mk11
Have tried wiggling, etc without success .. do you know if this program is better suited to PC or Mac?
Sent from my iPhone
> On 21 Nov 2020, at 13:12, Jim Unroe <rock.unroe@gmail.com> wrote:
>
> Ken,
>
>> On Fri, Nov 20, 2020 at 9:02 PM Ken Vernon <kennethjv@bigpond.com> wrote:
>>
>> Hey Jim, would it be a fair assumption that if the cable and chirp program works for my gt3tp and uv5r it should be ok for the GT3 mk11?
>>
>
> Yes. Try pressing on the plug a little during the cloning process.
>
> Jim
> _______________________________________________
> chirp_users mailing list
> chirp_users@intrepid.danplanet.com
> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
> This message was sent to Ken at kennethjv@bigpond.com
> To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com
_______________________________________________
chirp_users mailing list
chirp_users@intrepid.danplanet.com
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
This message was sent to Alan at straty10@gmail.com
To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com
_______________________________________________chirp_users mailing listchirp_users@intrepid.danplanet.comhttp://intrepid.danplanet.com/mailman/listinfo/chirp_usersThis message was sent to Ken at kennethjv@bigpond.comTo unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com