Madison,
When the cable is plugged in, the driver is loaded to that com port.
If you change com ports, the correct driver needs to be reloaded to the new port.
I believe that’s what you are experiencing.
John K3NXU
http://www.miklor.com/amazon amazon
From: chirp_users-bounces@intrepid.danplanet.com [mailto:chirp_users-bounces@intrepid.danplanet.com] On Behalf Of km9m-zig@comcast.net Sent: Wednesday, May 29, 2013 5:25 PM To: Discussion of CHIRP Subject: Re: [chirp_users] Radio still does not respond
try plugging the programming cable into a different usb port. I'm pretty sure this was my error problem, i use an older dell laptop.
I attempted to use the usb ports on the side, no joy.
for S & G's I plugged the cable into one of the usb ports on the back, and bingo..
Dell Laptop running XP-SP3.
GL and 73,
Zig - KM9M
_____
From: "Madison Jones" w5mj@hal-pc.org To: "chirp users" chirp_users@intrepid.danplanet.com Sent: Wednesday, May 29, 2013 10:38:32 AM Subject: [chirp_users] Radio still does not respond
To review my problem: Win7, Prolific 3.2.0.0 7/31/2007 [installed and reinstalled and reinstalled] on com 3, CHIRP 0.3.1, plug end filed down and pushed in HARD, and still get “radio did not respond” when I attempt to download from the radio. The miklor.com page has no suggestions for this error msg other than to file down the cable. Anything else in anyone’s bag of tricks?
Regards,
Madison Jones
W5MJ
