Well, try uploading your factory image to the radio. (You did save the factory image before you started programming the radio, right?) The factory image will restore the factory defaults..... You might have done something it didn't like or there might have had a bad bit gum up the works during the transfer.. it happens.
If you didn't save out a factory image, the UV-5X3 Yahoo group has one in its files section.
https://groups.yahoo.com/neo/groups/uv5x3/
I Just did a download and upload from mine, so I know Chirp isn't broken.
On 11/4/2017 21:49, jsonnentag--- via chirp_users wrote:
I connected everything and immediately (and easily) downloaded from the radio (BTECH UV-5X3) 1 time and then nothing else works. . . . No complete uploads or downloads now.
I made some edits to settings of the initial download and tried uploading it back. It stopped at about halfway . . . and like every time since then the screen flashed to all the LED icons activated (like when it is first turned on) and then nothing. Just sits there.
Disconnected, restarted computer, connected and tried downloading and it doesn't even finish downloading now. It gives an error about not the right amount of data were encountered and then exits. A second attempt might say the same thing, but after enough attempts it locks things up. No uploads (even of the original unmodified image file) finish.
I've tried volume settings from highest to very low. All the same results and on an inactive frequency.
Anybody have any ideas?
chirp_users mailing list chirp_users@intrepid.danplanet.com http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to KD8DVR at jl_wilkerson@att.net To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com