On Tue, May 28, 2013 at 11:59 PM, Madison Jones <w5mj@hal-pc.org> wrote:

I am a new user to the Baofeng F-11 so I might not be getting things correct, though I have reinstalled the cloning cable driver [it is on Com 3] using the Win7 procedure outlined by Wouxun and reinstalled Chirp. 

 

When I initially obtained the radio, I pulled up the stock channel program, changed it around a little and uploaded it to the radio using Chirp.  A few days later I  manually programmed several of the memories and deleted most of the stock memories.

 

Now, when going to the Radio tab on the Chirp software and attempting to Download from Radio, I get an error message which says “radio did not respond.”  I get the same error message when attempting to upload to the radio from Chirp.  Suggestions?

 

Madison Jones

W5MJ

 

Madison,

This is most likely caused by the programming cable not being plugged fully into the F-11. This is a common problem with the UV-5R and it equivalents.

If you haven't already, visit the Miklor.com website and take a look at the "Errors and Error Messages" page for guidance.

Jim KC9HI

_______________________________________________
chirp_users mailing list
chirp_users@intrepid.danplanet.com
http://intrepid.danplanet.com/mailman/listinfo/chirp_users