Hi Ted, Just a thought, did you use "run as administrator" when you installed it? Not doing so may cause problems. HTH.
Glenn
----- Original Message ----- From: "Ted" ted.g7obf@gmail.com To: "ask Q CHIRP software for radio" chirp_users@intrepid.danplanet.com Sent: Tuesday, September 15, 2020 10:44 AM Subject: [chirp_users] Error 5 - when trying to down load from KenwoodTS-2000
Hi
I running Windows 10 Build 19041 and Chirp build CHIRP daily-20200909 onHP Probook laptop with one only USB to serial adapter plugged in
To check com port selection (as shown on device manager) and that adpater/cableis working correctly I have used PuTTY to do loopback test to these instructions - https://www.digi.com/support/knowledge-base/performing-a-com-port-loopback-t...
This checked out OK
When selecting Radio/download radio and enetering the data after clicking OK get message " An error has occured could not open port COM4 (error 5) Acess is denied"
I have checked the rig is powered up (can hear tones) and serial lead is firmly pushed into the radio's serial port
Suggestions please
73 de Ted G7oBF
_______________________________________________ chirp_users mailing list chirp_users@intrepid.danplanet.com http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to Glenn at glennervin@cableone.net To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com