Isn't this something you would set in device manager for the port you are connecting to your radio?
Try searching for "device manager", then examine the serial port connected to the radio by right-clicking on it and changing the port settings...
Ken, N2VIP
On Apr 9, 2023, at 20:59, K5CG k5cg@hamoperator.org wrote:
Hello all,
I am not new to CHIRP but I'm setting up a new laptop and trying to manage memories on a (new to me) IC-7000.
I am using a DigiRig radio interface which has a built in sound card, CI-V port and uses RTS of the same COM port to key PTT.
When CHIRP Next 20230409 reads the radio it asserts RTS on the serial port which keys the transmitter.
RTS nor DTR are needed for CI-V so CHIRP should not assume that the port requires flow control. This should be the default for all CI-V based radios but a pair of checkboxes on the initial READ RADIO dialog to disable either RTS or DTR or both would also solve this issue.
I don't see a configuration dialog where port parameters can be changed.
In the meantime I can disconnect the 13 pin accessory connector on the back of the radio to prevent it from keying.
73 Danny K5CG
chirp_users mailing list chirp_users@intrepid.danplanet.com http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to Ken Hansen at ken@n2vip.org To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com To report this email as off-topic, please email chirp_users-owner@intrepid.danplanet.com Searchable archive: https://www.mail-archive.com/chirp_users@intrepid.danplanet.com