Hello,

        I just purchase a UV-5R+ and was trying to program it. I'm using
        the chirp-daily respository version.

        USB Cable: : Prolific Technology Inc. pl2303 3-2:1.0: pl2303
        device: /dev/ttyUSB0
        UV-5R+ Firmware: BFB297 (as reported via power-on)

        I get the typical unable to connect to radio, but when it is
        trying to clone I see on the HT the "Welcome...." message and
        then I get the timeout message.

        As for the cable, it does seem to be full seated. I have
        pressed and held the plug in to make sure and get the same
        results.

        First is there a debug mode I can turn on to capture the hand
        shake between the computer and the UV-5R+. I figure this would
        help the list.


                                                        Tony