28 Nov
2013
28 Nov
'13
7:09 a.m.
Mike,
I've not tried changing much using Chirp. I just got too busy.
The issue for me was getting Chirp connected to my radio. I can provide documentation when you are ready but the problem was a Ubuntu issue. Basically the user (me) did not have permission for a serial connection. Under Ubuntu USB appears to be a subset of the serial connection so if you do not have permission for a serial connection your USB connection fails. The symptom is clear and I have the screen snap for it. There is a simple command (terminal session) to establish permission and solve the problem.
--
73, Peace,سلام ,שָׁלוֹם, ειρήνη, Bruce ∞
On Tue, Nov 26, 2013 at 8:51 PM, Mike Agner ka3jjz@comcast.net wrote:
> Today, Bruce MacAllister wrote:
> ===========================
> Yes, I will. I did technical writing for pay and will do it as a volunteer
> now-retired engineer. I have a Kenwood TM-D700 and TH-F6A and the the MPC
> FX and Chirp files for them. I am new to Chirp and so see it from a newbie
> perspective with all the confusion inherent in just starting.
> ===============================
>
> Thanks vy much for the offer, Bruce - however please hold off for now. I
> have to set up a mailbox to keep your radio from being stolen (around
> here that's not an uncommon occurrence). Once
> I have that done, I'll email you off-list.
>
> Since you mentioned that you are a newbie to Chirp (me too) I wonder if
> you would discuss what you found difficult in using the software for the
> first time. That way as the Guide
> gets built, we can at least try to address at least some of these so
> that others don't run into the same issues.
>
> Here's one that had me stumped - I know you can use the stored
> configuration files to load certain freq ranges into the radio (if it
> supports them). But here's a question I never found the
> answer for - How can you append that data at the end of data you've
> already loaded, or perhaps put the configuration file in first, then the
> unloaded contents of your radio? Does it simply overlay the data,
> or push it down further in the editor?
>
> Mike
>
> ---
> This email is free from viruses and malware because avast! Antivirus
> protection is active.
> http://www.avast.com
>
> _______________________________________________
> chirp_users mailing list
> chirp_users@intrepid.danplanet.com
> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
>