[chirp_users] Yaesu FT2800M reading error

I got Yaesu FT2800M and was eager to use Chirp to program it. It failed reading data from this rig.

It ends up with message:

An error has occurred Failed to communicate with radio: Failed to read header

I use CHIRP daily-20161123 but older versions did not work too.

I tried reading with G4HFQ FTB2800 and it reads rig properly so I am sure my serial adapter works fine.

I see I am not the only one with this issue. There are few reports on this issue on Chirp site but none got response.

Any hope?