On a long shot, have you tried a factory reset, a complete reset not just

some parameters. I forget is the UV5 has two different levels of reset.

Then upload your image to the radio and see what happens. I know from 

experience that radios which get all their operating instructions from 

the non volatile firmware which is stored along with modifiable ram

can get corrupted and cause some real whacky symptoms. If you have 

a current image of your channels give it a try. When the radio reboots

it will upload a fresh operating system from its firmware. Then 

you can upload your memory image.  Might be the simple fix and I certainly

would be the first to try it. 

---

From: Donald Stewart <djstewart@metrocast.net>
To: Discussion of CHIRP <chirp_users@intrepid.danplanet.com>
Sent: Thursday, August 15, 2013 6:14 PM
Subject: Re: [chirp_users] Chirp and radio parameters not agreeing

Can't see an "R"  so still not sure.  Maybe have to come back to this later.


On 8/15/2013 6:06 PM, Andrew wrote:
> I've just had a test with my UV-5RA... This could happen if your
> channels are duplex frequencies and you have Reverse turned on - then it
> will be displaying the TX frequency not the RX frequency. If there's an
> "R" in the display, press "*" and it should return to normal.
>

_______________________________________________
chirp_users mailing list
chirp_users@intrepid.danplanet.com
http://intrepid.danplanet.com/mailman/listinfo/chirp_users

_______________________________________________
chirp_users mailing list
chirp_users@intrepid.danplanet.com
http://intrepid.danplanet.com/mailman/listinfo/chirp_users

No virus found in this message.
Checked by AVG - www.avg.com
Version: 2013.0.3392 / Virus Database: 3211/6579 - Release Date: 08/15/13