On Tue, Jan 7, 2014 at 11:06 AM, kdufour . <kdufour@gmail.com> wrote:

am running 2.0.2.1 for XP

If you are running this driver on XP and getting the "radio did not respond" error, then there are two possibilities. Either the programming cable is not fully plugged into the radio (the most likely cause) or the programming cable is defective (possible but not as likely).

Many users swear that their programming cable is fully plugged in but are amazed when they give it a wiggle and a firm push and notice it go in just a little further. See the "Errors and Error Messages" page on the miklor.com website.

http://www.miklor.com/HT/HT-ErrorMess.php#error1

Jim KC9HI 

_______________________________________________
chirp_users mailing list
chirp_users@intrepid.danplanet.com
http://intrepid.danplanet.com/mailman/listinfo/chirp_users