Hi folks,
I've got a new-to-me Yaesu FTM-3100R. Picked up a cable from BlueMax49ers to run with CHIRP. I downloaded the radio using the FTM-3200D R template as per the CHIRP home page. Downloading and uploading works fine.
I copied and pasted from my Yaesu FT-60R img 63 of the frequencies I monitor that are covered by the FTM-3100R. Uploading those to the radio works fine and downloading shows them all in memory.
However, I notice that when I scan all 63 frequencies the radio only scans the first 14. The display just stops on the 14th location while the numbers under MR keep counting up to 63. Then it cycles back to location 1. I have the radios side by side and the FT-60R scans all the locations while the FTM-3100R only the first 14.
The specs say the radio has 199 memory locations which is consistent with the CHIRP img * 199 "basic" memory channels, numbered "1" through "199".
But the CHIRP image doesn't show the home channel or any of the L or U locations. * A "Home" channel, providing storage and quick recall of one prime frequency. * 10 sets of band-edge memories, also known as "Programmable Memory Scan" channels, labeled "L0/U0" through "L9/U9".
Does anyone out there have an FTM-3100R and can let me know if I'm doing something wrong? I'm wondering if there's some issue with the FTM-3200D R template WRT the FTM-3100R.
Thanks from a first-time poster!
73 Andy Zaayenga KD2SME Yaesu FT-60R, Yaesu FTM-3100R