This question is prompted by the discussion below, and by my surprise at finding that I had set the power to LOW when the memory was programmed to HIGH, and it quickly reverted to HIGH. I soon learned about using the keypad to change it at runtime. I have since reprogrammed all my powers to LOW.
~R~ NE1EE
On 2016-04-25 17:12:-0400, you wrote:
On Mon, Apr 25, 2016 at 1:33 PM, kc6iih via chirp_users chirp_users@intrepid.danplanet.com wrote:
Tone mode in simplex has no effect. You are not using a repeater . To further the point, tone no matter the setting won't do anything unless the repeater is using a tone. In that case you must have it set correctly.
Jock KC6IIH
Tone Mode are just as effective when using simplex as it is using a repeater. Although tones are seldom used on ham frequencies when using simplex, their use on commercial simplex channels is quite common and CHIRP supports it fully.
Jim KC9HI