Hi Kyle,Just a few thoughts: can you get a nearby ham to listen on the input of the repeater? You will then know, for definite if you are modulating or not. Or even to be sure you're transmitting on the right frequency.Talking of modulation... what is your TX set to (is it adjustable?!) There will be something like wide or narrow.Are you sure about the ctcss / PL tone frequency? I just Googled it, and I can only find 146.2.Some of this you'll have done I'm sure. Otherwise - hope it's useful.Good luck nailing it.SimonG4PEMOn 30 Jun 2017 5:29 a.m., "Kyle Colyer" <colyer.kyle@gmail.com> wrote:Hello.I have a baofeng hp 82 and I used the older software to program it and it works great with our repeater. Then I got a btech 50 and downloaded the chirp software to program it but I cannot get it to work right off our repeater. One of the problems is that the pl tone box only has a drop down box and preset pl tones and ours is 146.3. I can't figure out how to put that tone in the chirp program. I have tried to manually input it into the radio itself and it won't work. I had this problem with the bf82 also before I got the software and programmed it with the computer instead of putting it into the radio. Can anyone help?
_______________________________________________
chirp_users mailing list
chirp_users@intrepid.danplanet.com
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
This message was sent to Simon Rodda, G4PEM at simon.rodda@gmail.com
To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com
_______________________________________________
chirp_users mailing list
chirp_users@intrepid.danplanet.com
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
This message was sent to D.J.J. Ring, Jr. at n1ea@arrl.net
To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com