Thank you for reading this.

I bought a Baofeng UV-82HP about four months ago and I cannot get Chirp
to read from the radio, or in fact to do anything with the radio.

I'm running Chirp under Kubuntu and have tried every Chip daily version
over the past four months. This is the error message that I receive when
I attempt to read from the radio:

"Radio did not respond"

These are the entered parameters:

/dev/ttyUSB0
Baofeng
UV-82HP

I have read and write access to the serial port which is the same port
that I use for several application including programming an Arduino
board. I have tried several different Baofeng models, just in case, with
the same result.

I've trimmed the plastic from the plug so that it slips into the radio's
sockets more easily. I've attempted to read from the radio in both
channel and frequency modes. Finally, I've searched the Internet for
even the slightest clue but to no avail.

I do not know anyone who owns a Baofeng radio or who uses Chirp. So this
mailing list is my last hope.

Any clues at all will greatly appreciated.

--
Regards,
Phil

_______________________________________________
chirp_users mailing list
chirp_users@intrepid.danplanet.com
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
This message was sent to Dwayne Elliott at ke6pls2@gmail.com
To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com