Hi Timothy you probably have a "us model", you should have selected specific driver, "FT-857/897 (US)" in the list, I'm pretty sure this is the reason of the clone error.
To restore your radio you can download to chirp using the right model, at the end of clone the radio have to show no error. In case of error please stop here and send me the debug log with the .img file. If clone end correctly you can copy/paste from the previous image all memories and then display settings to manually copy them. Finally you have to upload the image (the new one I mean) to the radio.
If you can wait till tomorrow I can copy all settings and memories from the "bad" file to a good one if you send me both.
Hope this can help.
73 de IZ3GME Marco
On Tue, 25 Jun 2013 11:45:40 -0600 Timothy Buchanan timothyebuchanan@hughes.net wrote:
Following the wiki procedure, I put my 857D in clone mode, set Chirp to download from radio, then pressed the send button on the 857D. It showed sending and the Chirp window populated. The 857D then showed error. I shut it down, then repowered, and all seemed ok.
I made a few edits to the .img file in Chirp. Then, again following the wiki, I put the 857D into clone receive and hit upload on Chirp. The clone window completed, then the 857D immediately, without intervention, went into clone sending mode and froze there.
Eventually I shut down and repowered, to find that all memories had vanished, along with all other settings (mike select, etc). In short, a hard reset back to factory defaults. Not what I wanted at all.
Has anyone else had this problem? Is there a fix? Thanks for any help.
Timothy Buchanan (Buck)
"Time is our only resource, humor our only defense."