When you are going thru the clone process, always read the radio first, modify your file, then write to the radio. When the instructions says to push the Set button, it is the fastest push you can do and release, don’t press too long. 



You have to select the USB port that your radio is connected to.  

73

DR

On Mon, Sep 7, 2020 at 5:28 PM joe <joe@joeshapley.com> wrote:

Hi everyone,

Windows 10 computer

I am trying to clone the Yaesu FT8900R (this is the first time)

I use CHIRP and I follow the CHIRP instructions (same as in Yaesu manual)

I turn on the radio, go to F6 "clone start", then push "set"

Nothing happens...after a few seconds, I get error message stating it could not find the item location (com port).  Tried several times on all four active ports.

Checked "device manager" and the four ports are active and well

Any help or suggestions will be greatly appreciated

Joe

_______________________________________________
chirp_users mailing list
chirp_users@intrepid.danplanet.com
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
This message was sent to D.J.J. Ring, Jr. at n1ea@arrl.net
To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com

_______________________________________________
chirp_users mailing list
chirp_users@intrepid.danplanet.com
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
This message was sent to Jardy at jardy72@yahoo.com
To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com