Is the problem potentially Smart Screen? Refer to http://www.miklor.com/COM/UV_CHIRP.php (section 2)
John
From: chirp_users-bounces@intrepid.danplanet.com [mailto:chirp_users-bounces@intrepid.danplanet.com] On Behalf Of Mike Raymond Sent: Tuesday, July 21, 2015 9:25 AM To: Discussion of CHIRP Subject: Re: [chirp_users] Baofeng UV-5R and settings/squelch_levels
Issue:
Cannot get a driver to function on my w8.1 machine using
same cable (with FTDI chip), Win_Driver_Prolific_3_2_0_0
and UV-3R transceiver software that all works FINE on my
big 64b W7 machine incl Chirp.
Any suggestions on how to solve the W8.1 problems????
The W8.1 Dell Laptop has 3gb ram, 500gb HD and otherwise
runs flawlessly.
73
On Sun, Jul 19, 2015 at 8:43 PM, Pavel Milanes Costa co7wt@frcuba.co.cu wrote:
El 19/07/15 a las 20:21, Jim Unroe escribió:
On Sun, Jul 19, 2015 at 11:20 AM, Pavel Milanes Costa co7wt@frcuba.co.cu wrote:
Hi, I'm new to the list...
I was searching the list archives for this, but found no answer, so here it goes...
The squelch levels for VHF/UHF on the settings > service settings options do work for the Baofeng UV-5R?
My Baofeng is about 10uV in VHF and ~2.0uV on UHF, so VHF reception is hard, may be it has to do with the SQ level, it has 25 as SQL 0 for VHF and 19 on SQL 0 for UHF.
So before I play with that values I want to know if this setting will really work with my radio.
I'm using chirp-daily-20150702 here...
73,
-- M.Sc. Pavel Milanes Costa, CO7WT SYSOP Nodo Gateway CO9JAZ Ciudad de Camagüey, Camagüey, Cuba. Cell: (+53) 53-847819
Este email fue enviado usando packet radio a 9600 baudios This email was sent using Amateur Packet Radio at 9600 baud
There is no guarantee that it will work. Feedback shows that it works for firmware version BFB291 and newer. The settings won't show up if the firmware version is older than this. The improvement seems to vary from firmware version to firmware version and model to model.
Always save your radio's channels and settings before you start making any changes. That way you can always get back to where you started. It appears that you have test equipment available. All you have to do is change one setting to see if it works. If it doesn't, then change it back.
Jim KC9HI
Thanks for the answer Tim.
My firmware is BFB297 N5R-20, so it may work... I will try and get back to the list to report..
73
_______________________________________________ chirp_users mailing list chirp_users@intrepid.danplanet.com http://intrepid.danplanet.com/mailman/listinfo/chirp_users To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com