On Sat, May 20, 2023 at 10:27 AM David Osborne <dosborne1969@gmail.com> wrote:
>
> Newbie here. I am trying to get some radios working for our VFD. It is a very small area, so we don't have a lot of money for radios.
> I have all the frequencies from a neighboring VFD. Their radios are kenwood TK-5220.
> My problem is that the RX and TX are different frequencies. I have used the split to put in the TX frequency. After sending to the Tenway UV 82 Pro, I can receive voice, but I can not send voice.
> The Kenwood file shows a QT/DQT Dec and a QT/DQT Enc value. I do not know where to put this info. in the chirp software.
> Thanks for any help you can provide.
> --
> *David*

They are the selective squelch (CTCSS tones and/or DCS codes) used by
the VFD. They are set up in CHIRP using the Tone Mode and its
associated fields. Without knowing what the QT/DQT Dec (receive) and
QT/DQT Enc (transmit) values are, it isn't practical to tell you how
to set them up in CHIRP.

Jim KC9HI
_______________________________________________
chirp_users mailing list
chirp_users@intrepid.danplanet.com
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
This message was sent to David at dosborne1969@gmail.com
To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com
To report this email as off-topic, please email chirp_users-owner@intrepid.danplanet.com
Searchable archive: https://www.mail-archive.com/chirp_users@intrepid.danplanet.com