Hi all I have agree with Dave I have been fooled many times thinking the plug was seated when it wasn't. I built an interface box for doing my programming of these radios and had to remove the the plug covers so the plug could be seated properly into the radio, so as Dave says make sure it is pushed in all the way, it takes a lot pressure to seat it

Randy

On May 14, 2016, at 10:50 PM, Dave Felt <feltdd@verizon.net> wrote:

Maybe have to plug it in REALLY HARD... as they say...

On 5/14/2016 4:19 PM, Ron Maruska via chirp_users wrote:

I have a Baofeng uv-5r and the radio is garbage and the Baofeng software is scrap. I sent an email to Baofeng about the software and they would not support it. I told them to get F#*&ked and said I would post there reply on Ebay.

On Saturday, May 14, 2016 5:01 PM, Eugene <enine@ninefamily.com> wrote:

I ordered a programming cable for my Baofeng UV-5RV2+ and the first time
I tried to download from the radio I got 25 channels. Trying again only
channel 5 and 6 would show up. I upgraded the the latest version of
CHIRP and now when I try the radio just reboots and CHIRP says an error
has occured, radio does not respond. Did I get a bad cable?

Thanks

_______________________________________________
chirp_users mailing list
chirp_users@intrepid.danplanet.com
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
This message was sent to Skid at ve3jpu@me.com
To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com