I have the cable branded Baofeng. I uninstalled the new version and installed v3.2.0.0. Following directions, I unplugged the usb cable, ran the install then plugged the cable back in. Windows did not even see that a new device has been introduced. I had to shave off a little of the connector that plugs into the radio or it would only go in half way. I am sure it is seated fully now....

Help!

On Fri, Jan 23, 2015 at 8:59 AM, Jim Unroe <rock.unroe@gmail.com> wrote:

On Fri, Jan 23, 2015 at 8:18 AM, Rick Osgood <rposgood@gmail.com> wrote:
> Is this model supported by Chirp or can I select a different model? Windows
> 7 finally saw the usb connection and it is now listed as an unknown device?
>
> Thanks for the great work!
>
> --
> Rick Osgood

>From the Supported Radios list on the CHIRP home page...

Baofeng/Pofung
BF-F8HP (in daily builds)


If you have a programming cable with a Prolific type chip, be sure to
downgrade your installed driver to v3.2.0.0.

http://www.miklor.com/COM/UV_Drivers.php

Jim KC9HI
_______________________________________________
chirp_users mailing list
chirp_users@intrepid.danplanet.com
http://intrepid.danplanet.com/mailman/listinfo/chirp_users

--

Rick Osgood

411 Walnut Street #9722

Green Cove Springs, FL 34023

chirp_users mailing list
chirp_users@intrepid.danplanet.com
http://intrepid.danplanet.com/mailman/listinfo/chirp_users