Their response to me complaining about failure to release new firmware....
Curley
All of our models work with CHIRP as a distributor we work with CHIRP more than any other distributor - we are the only BaoFeng distributor that also insures our firmware matches on the same model to allow for easier templates
If you intended to write the factory you can go to: baofengradio.com On Jun 8, 2016 3:10 PM, "Jim Unroe" rock.unroe@gmail.com wrote:
On Wed, Jun 8, 2016 at 4:51 PM, Steve London n2icarrl@gmail.com wrote:
Success !
It ended up being three issues:
- The speaker and mic jacks on my new UV-5RV2+ are not centered. They
are off by a few mm. Therefore, my programming cable would not seat correctly. Trimmed the cable plug with a utility knife until it seated properly. Incidentally, my old UV-5RA has the jacks centered.
- While trimming the cable plug, I accidentally cut the ground wire.
After repairing that, the old UV-5RA could be read with CHIRP.
- The 2014 version of CHIRP does not talk to the new UV-5RV2+. The
latest build does work correctly with the UV-5RV2+. Thanks !
A learning experience.
73, Steve, N2IC
I'm glad to see you have it worked out.
UV-5R style radio development for CHIRP has been quited active over the last 4+ years. Except for a few recent models that chose not to provide their firmware version, it you cannot program your UV-5R variant, there is a 99% chance that it is a cabling problem (device driver and/or connection of the cable to the radio).
Jim KC9HI _______________________________________________ chirp_users mailing list chirp_users@intrepid.danplanet.com http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to Rick Frazier at ricknbrook@gmail.com To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com