I've been toggling between hide & unhide columns and compaing. If I type info in Hide mode, Tone usually just shows 88.5, which I've been changing to match the Tone when all columns are shown. I misunderstood and thought you could only transmitt with ToneSql set to TSQL.

thx, and as you have guessed I'm a newbie,

-jm

From: "Jim Unroe" <rock.unroe@gmail.com>
To: "Chirp" <chirp_users@intrepid.danplanet.com>
Sent: Sunday, April 2, 2017 4:53:22 PM
Subject: Re: [chirp_users] Fwd: baofeng 82c

On Sun, Apr 2, 2017 at 7:42 PM, Jim McIver <jmciver@lmtribune.com> wrote:
> Dang, thought I had it figured out. Search and Rescue in my area doesn't use
> any ham frequencies, just frequencies between 136-174mhz. I have 128
> channels in my kenwood tk-2170 that includes a 5 county area. I'm probably
> looking at months to figure it out. The kenwood shows None in the QT/DQT
> Dec, so I don't know if I should leave the Tone to the default of 88.5.
> Tedious typing as I only have 17 of the 128 keyed so far and looks like I'll
> have to change some when I figure what might work.
> thx,
> -jm

Jim,

Like I explained earlier, when Tone Mode is set to "(None)", it
doesn't matter what the rest of the selective squelch columns are set
to because they are all ignored. If you would enable "Hide Unused
Fields" (which is the CHIRP default), then when Tone Mode is set to
"(None)", none of the default values would show because all of the
fields from Tone to Cross Mode would be blank.

Jim KC9HI
_______________________________________________
chirp_users mailing list
chirp_users@intrepid.danplanet.com
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
This message was sent to Jim M at jmciver@lmtribune.com
To unsubscribe, send an email to chirp_users-unsubscribe@intrepid.danplanet.com